Flat Tabletop Conversion Kit for Korg MS-20iC Legacy Controller

Note: links to listings are affiliate links for which the site may be compensated.

via eBay

"Transform your bulky MS-20 Legacy Controller into a flatter modded table top version with my custom build handmade plastic side panels. The carefully measured holes for the screws are pre-drilled and all you have to do is remove the back panel on the controller, unscrew the side panels and then replace them with my panels (I will include a video on how to best perform the conversion) and the controller becomes much less space consuming and quite unique looking. After the transformation it fits into a typical carry-on suitcase and the semi-open back can be used as a kind of handle to easy carry the controller around.

This listing is ONLY for 2 plastic side panels, not the controller itself! And since they are handmade, they may not look as polished as if they were made in a factory, but they look decent and are very sturdy when installed. They also may look slightly different (and hopefully better) than the prototype in the photos, since I'm still working on perfecting my manufacturing skills.

Disclaimer: The conversion (when done correctly and carefully) doesn't harm the controller and can always be reversed if needed. However, performing the conversion is completely your own risk and you acknowledge that I will not be responsible for damage or injury when you convert your controller!"