MATRIXSYNTH: Knobcon 5 Synthrotek ASTRONOISE Eurorack or Console DIY workshop

Tuesday, August 23, 2016

Knobcon 5 Synthrotek ASTRONOISE Eurorack or Console DIY workshop

Published on Aug 23, 2016 synthrotek

"Knobcon 2016 bonus! The AstroNoise at KC can be built as a Eurorack module OR as a standalone circuit that you can wire into a case later. In the past it has just been a standalone circuit, but the lofi wizards of Synthrotek have modded the board to fit in a 10HP DIY Blank Panel. All kits will come with the parts needed for both the standalone circuit or Eurorack mod, no extra charge. The PCB will be cut ahead of time as needed for the mod, and the DIY Panel will be pre-drilled. The jacks provided will be 3.5mm.

The workshop will be taught by Scott Rise of Division 6 fame. Soldering irons, solder, and other necessary tools will be provided. You can check out the assembly instructions ahead of time here (the Eurorack mod is at the bottom of the page).

This circuit requires a medium-ish skill level. Have you soldered something successfully before? Then you're good to go.

Please purchase this workshop ahead of time so we know how many kits to bring!"

No comments:

Post a Comment


©2018 Matrixsynth - All posts are presented here for informative, historical and educative purposes as applicable within fair use.
privacy policy