Sunday, July 30, 2017
How to add knobs to your Korg Volca, SQ-1 or Moog Werkstatt synths
Published on Jul 30, 2017 Mike Sisk
"In this video I show a simple way to make knobs that are too big fit onto a Korg Volca, SQ-1 or Moog Werkstatt.
To do this all you need is a plastic drinking straw and some knobs. I used a section of the straw and a shim to go between the knob and the shaft of the pot. Then tightened the set screw to hold i in place.
The knobs I used were from Mammoth Electronics, they come in many different colors and only cost $0.80 each. The straw was from McDonnald's and was free.
Link to the knobs I used:
https://www.mammothelectronics.com/co..."
PREVIOUS PAGE
NEXT PAGE
HOME
© Matrixsynth - All posts are presented here for informative, historical and educative purposes as applicable within fair use.
MATRIXSYNTH is supported by affiliate links that use cookies to track clickthroughs and sales. See the privacy policy for details.
MATRIXSYNTH - EVERYTHING SYNTH
© Matrixsynth - All posts are presented here for informative, historical and educative purposes as applicable within fair use.
MATRIXSYNTH is supported by affiliate links that use cookies to track clickthroughs and sales. See the privacy policy for details.
MATRIXSYNTH - EVERYTHING SYNTH
Subscribe to:
Post Comments (Atom)
No comments:
Post a Comment
Note: comments that insult people will be removed. Critique on gear is allowed. Do not ask if listings are still available. Click through auction links to check yourself. Posts and pics remain for historical purposes. To reduce spam, comments for posts older than one week are not displayed until approved (usually same day).