BURG 1K Synth Kit Setup - Session Two #volca #DrumBruteImpact #Arturia #ms70CDR

Published on Nov 15, 2018 ollilaboratories

"If you like my stuff please support me on http://music.ollilab.com/ and https://www.patreon.com/theBURG

Hi All, this is the second jam on the BURG1K setup. This track is a bit different than the first one. I wanted to break out from using 4/4 patterns and do something a bit slower, but still with some groove.

The drumbrute has just a little bit of swing/shuffle.. to give that moving feeling and to make sure it does not become too static.

On the volca bass, i have several patterns i switch between that has the second VCO recorded with different notes, and by switching the patterns i can sort of play a pre defined melody. :) This helps with variation in the song.

I still have not decided how to expand the setup with fully. I do have a mixer incoming to ensure proper stereo recording, the behringer 1002B and also a EHX 720 stereo looper.

I a hoping to be able to use these in my upcoming videos.

Gear used:

- KORG volca keys
- KORG volca bass
- Arturia Drumbrute Impact
- 2x Zoom MS-70 CDR FX pedals
- Behringer mx-400 mono mixer
- 2 track Recorder, Zoom H5

Stereo track Post processing

- Izotope Limiter and Compressor
- Cubase native EQ (low end roll off and minor high end boost)

Wiring/schematics

- Arturia drumbrute, mono - mx400
- volca bass, mono - mx400
- volca keys, mono - ms70, mono - mx400
- mx-400, mono - ms70 CDR - stereo out to Zoom H5

FX settings

- Volca keys ms-70 - silky chorus, tape echo, particle reverb
- mx-400 ms-70 - spring (reverb) and analog DLY

Future Gear Additions

- Electro Harmonix 720 Stereo Looper
- Behringer Xenyx 1002B

I hope you will enjoy this one!

BoOoM!"