microKORG Overlays & BACKGROUND RADIATION Patches for microKORG & MS2000

MicroKorg Overlay Installation - oversynth.com - Human Oversynth

"To install the overlay, you will need to remove all of the knobs and screws from the front panel of your MicroKorg synthesizer. The four main screws can be removed using a 3/32" or M2.5 hex key wrench. The two parameter selection knobs can be removed using a 1/16” hex key wrench. These hex key wrenches are common items that can be purchased from most hardware stores or from our oversynth.com online store. The other knobs do not require a hex key wrench to be removed, but you may need to gently pry them off using a letter opener or butter knife. Once the knobs and screws are removed, peel off the backing from the adhesive strips on each overlay and place the overlays over the front panel of your synthesizer. The removable adhesive is low-tack so you can easily reposition the overlays if needed for proper alignment. Once the overlays are in place, re-attach all the knobs and screws."

BACKGROUND RADIATION - 128 Patches - Dark Ambient, Dystopian, SciFi - For microKORG & MS2000

Human Oversynth

"Sound Pack available now from www.oversynth.com

This video was recorded straight from the microKORG's output to a Zoom H6. Minor compression was used while editing the video. No other effects or processing was used.

West Coast Textures, Dystopian, Dark Ambient, SciFi, Deep focus, Investigative, and Contemplative --- Explore the dark meditative side of your original microKORG, microKORG S, or MS2000 synthesizer.

These sound pack patches are a collection of long-sustaining drones, pads, and mellow arpeggios. There are also a few utility drum sounds (bass drum, snare, hi-hat, etc.) at the end of the pack. The arpeggio sounds can also be used with an external step sequencer by simply turning off the patch's arpeggiator.

This sound pack contains 128 custom sound patches for the original Korg microKORG, microKORG S, and MS2000 synthesizers. To use this sound pack, you will need one of these synthesizers, a computer, two 5-pin MIDI cables, and a traditional 5-pin MIDI interface for your computer.

NOTE: THIS SOUND PACK WILL **NOT** WORK WITH THE MICROKORG XL or R3 synthesizers.

www.oversynth.com"