video by gstormelectro
"Audio + Video by G-Storm Electro c. 2021
Today a quick un-edited video announcing the 2xADSR version 1-2 dual envelope. Available as a DIY project or assembled version. Check http://reverb.com/shop/gstormelectro for availability."
via G-STORM on Reverb
"2xADSR is a dual envelope module in 8HP Eurorack format. Each envelope is an independent Attack-Decay-Sustain-Release linear contour. Each envelope takes a gate input, puts out a positive-voltage contour and a buffered negative-voltage (DC inverted) contour. New for version 1-2
Functionally everything is the same except the added capacitors + spdt switches for long/short response. Previously was only short response time. Also:
added 100n filtering capacitors
eliminated U4 by simplifying inverted output circuit
added 4x 100R current limiting resistors to outputs
Horizontal aligned components
single screw post, previously was 2 screw posts
This is the assembled version. Included is a 15cm 10-to-16 pin ribbon connector. Just plug into your system and go!
Module Depth: 22mm
Current Measurements: 16mA/+12V, 2mA-12V, 0mA/+5V (not used)
Contour Scope Measurements
fast mode:
- attack range 1ms to 1s
- release 1ms to 3.5s
slow mode:
- attack range 10ms-12s
- release 10ms-35s"
No comments:
Post a Comment
Note: To reduce spam, comments for posts older than one week are not displayed until approved (usually same day).