Sunday, May 02, 2021
2021/05 - Userwave & Wavetable editing on Synth Programmer for Microwave
video by Stereoping
"The firmware update 1.62 for the #Stereoping Programmer's Microwave edition introduces #Wavetable editing & randomizing plus #Userwave randomizing and drawing. And there is a new PREFS setting optionally preventing the STARTWAVE knobs to run into the tri/sqr/saw waveforms to the end of each wavetable. The video shows all of these features in action."
PREVIOUS PAGE
NEXT PAGE
HOME
© Matrixsynth - All posts are presented here for informative, historical and educative purposes as applicable within fair use.
MATRIXSYNTH is supported by affiliate links that use cookies to track clickthroughs and sales. See the privacy policy for details.
MATRIXSYNTH - EVERYTHING SYNTH
© Matrixsynth - All posts are presented here for informative, historical and educative purposes as applicable within fair use.
MATRIXSYNTH is supported by affiliate links that use cookies to track clickthroughs and sales. See the privacy policy for details.
MATRIXSYNTH - EVERYTHING SYNTH
Subscribe to:
Post Comments (Atom)
No comments:
Post a Comment
Note: comments that insult people will be removed. Critique on gear is allowed. Do not ask if listings are still available. Click through auction links to check yourself. Posts and pics remain for historical purposes. To reduce spam, comments for posts older than one week are not displayed until approved (usually same day).