Note: Auction links are affiliate links for which the site may be compensated.
via
this auction
"This unit has both the HAWK-800 and the AtomaHawk upgrades installed, as detailed here:
http://patrioticduo.tripod.com/hawk800...
http://patrioticduo.tripod.com/hawk800...
The upgrades/mods add the following features:
NEW SOUND FEATURES:
1) Portamento mono mode with slide rate parameter stored per patch.
2) Tremolo - apply either LFO1 or LFO2 to the volume of either of the DCO's volume with control over Tremolo depth for each DCO.
3) The single LFO is now two (LFO1 and LFO2) and two more super LFO's (SLFO3 and SLFO4) have been implemented.
4) All four LFO's have triangle, sawtooth, sine, square PWM and random sample and hold waveforms. All waveforms can also be inverted.
5) All four LFO's have free running modes.
6) LFO1 and LFO2 delay type select - allows the LFO's to cycle at note on and then stop cycling when the delay timer expires. This allows the reversal of its original behavior where the LFO delay timer must expire before the LFO begins to cycle.
7) LFO2 sync to MIDI clock.
8) EG3 retriggering sync by MIDI clock.
9) Note triggered sequencer transpose - You can now select a global parameter that will set up the keyboard to transpose the playing sequence. You can also set the mode to allow MIDI to transpose the sequencer too.
10) Resonance can now be modulated by LFO's and the envelope generator.
11) The LFO1 frequency can be modulated by SLFO3.
12) The LFO2 frequency can be modulated by SLFO4.
13) Random sample and hold waveform clocked by the on board seq. or MIDI clock.
14) Random sample and hold waveform clocked by sequencer repeat.
15) DCO harmonics can now be modulated by any of the four LFO's.
NEW MIDI FEATURES:
1) MIDI controllers (special and NRPN) for all original and extended parameters.
2) MIDI standard controllers implemented for LFO1 rate, VCF cutoff and resonance depth.
3) MIDI controllers for setting Poly, Hold, Chord and Portamento modes.
4) MIDI sustain controller send and receive.
5) MIDI SYSEX single patch dump send and receive.
6) MIDI SYSEX bulk patch send and receive.
7) MIDI EX-800 SYSEX dump receive (sequencer and patches).
8) MIDI Poly-800 MK2 SYSEX patch dump receive (patches only).
9) MIDI user initiated SYSEX HAWK-800 bulk dump all patches.
10) Selectable Omni On, Off or Auto on power up.
11) Keyboard MIDI TX channel selection (1-16 or no MIDI TX).
12) Joystick MIDI TX channel selection (1-16 or no MIDI TX).
13) MIDI soft thru of all messages.
14) Sequencer MIDI time code send on/off.
15) Chord mode synchronization SYSEX send - if cascade sync mode is selected then pressing the chord key will send a SYSEX message to set up the chord progression table. This allows a slave unit such as an EX-800 to operate in chord mode with the same chord structure as the master unit.
16) MIDI patch bank selection (1 of 4).
17) MIDI note on velocity sensitivity where VCF and envelope generator parameters can be influenced by incoming MIDI note velocity data.
NEW USER FEATURES:
"Ok, I have no idea what to call this, frankensynth, poly 1600, dual poly, super poly 800?
cE9s4PsOsIBRooM1vr8Q~~60_57.JPG)
