"Dave Wright of Not Breathing took a dead Crumar Stratus and did this to
it, using various modules, mostly devised by Synth-DIY list regulars.
In fact, Dave is one of the most prolific DIYers I've ever seen. Look at
the galleries at carrionsound.com for more."
Eric Barbour
owner, METASONIX
senior editor, VACUUM TUBE VALLEY
the guts:
ray wilson 1v/oct single bus keyboard pitch/gate extractor - gate/trig/pitch output on back - cv/gate inputs bypass - portamemto2 - on breadboard
2 ray wilson VCOs - four layer slider mixer controls vco1/2's saw and pulse outputs - knobs control sine outputs of both
to mixer - knob controls amount of cross modulation from vco2's tri to vco1's cv in - 1v/oct in on/off both, pulse width
modulate VCO1 from VCO2 tri switch
1 noise source using old crow's PIC code for digital noise - to mixer
1 CGS DC Mixer (slider bank/varios pots)
1 PAIA Dual VCF w/ ASR - bandpass/highpass/lowpass for both stages via two rotary switches, cut off and Q knobs for
both, ASR w/ led - attack/decay and depth knobs, LFO/ADSR cycle, Gate IN On/OFF switch
asr is dedicated to both filters cutoff
JOYSTICK controller controlls X= VCF1 Cutoff Y = VCF2 Cutoff - knobs for depth
1 4011 Cmos based RING MODULATOR on breadboard - grabs vco 1 + 2's pulses - to dc mixer
1 CGS Psycho LFO - rate, glide, depth knobs, LED, VCO1 or VCO2 on/off routing switch
1 Rene Schmitz ADSR on breadboard - attack/decay/sustain/release knobs, wired straight to VCA on breadboard
1 Rene Schmitz VCA using 1583 transistor - manual volume pot on breadboard
2 Cats
No comments:
Post a Comment
Note: comments that insult people will be removed. Critique on gear is allowed. Do not ask if listings are still available. Click through auction links to check yourself. Posts and pics remain for historical purposes. To reduce spam, comments for posts older than one week are not displayed until approved (usually same day).