5/3-5/25 (2 patterns) Simmons SDS6 & SDS1 + DR-55 clone + DigiTech HM4 + EML 200 + (in description)

video upload by Cfpp0

"5/3-5/25 (2 patterns) Simmons SDS6 & SDS1 ('flange snare') + Doctor 55 clone + DeltaLab Effectron II + TAMA DS200 + ElectroComp EML 200 + Ace Tone MP-4 + DigiTech HM4 Harmony Machine + Alesis MIDIVERB II + MXR 136 Dual Limiter + DBX 119 + Peavey 1300

This Simmons SDS6 was dead, but it’s been serviced by The Simmons Guy. It got converted from 220v to 115v with a rebuilt PSU, a cloned reset circuit on a custom PCB, traces rerouted on the dead expansion PCB with new caps and trimmer, new RAM ICs, new batteries, plus a MIDI in mod and, due to a lot of corrosion, plenty of new traces, caps, resistors, diodes, and so on. I’m still working my way through the SDS6 manual, but it’s already been a real pleasure to have such a giant sequencer. It makes the Doepfer Trigger Matrix seem microscopic. Considerable noise from the SDS6 is audible through the (always noisy) Doctor 55 clone. Not sure why. Anyways, the SDS6 is triggering the DR-55, which runs through the DeltaLab Effectron II, overloading the preamp limiter, fully wet, full feedback. In the first pattern, the Effectron II is set to Flange Lo (16ms). And then Double (64ms) in the second pattern. The SDS6 also triggers the SDS1, with a “flange Snare” EPROM and with the auto run feature on, and it’s panned a bit right with reverb from the Alesis MIDIVERB II. The SDS6 also triggers the TAMA DS200, which runs through the Ace Tone MP-4 for saturation and spring reverb. The DR-55 is also running through the Peavey 1300, which is panned left and has a lot of reverb from the MIDIVERB II. I did an overdub where I ran the whole first pattern through the DigiTech HM4 harmonizer, but the detuned copy sounded better when placed early, before the high pitched original. So if you are wondering why you can’t see those detuned notes on the SDS6 matrix, that’s why. You can see those notes being leveled by the MXR 136 limiter in the cutaway shots. The second pattern has drones from the EML 200 synthesizers: one is constant, panned left, and getting louder the whole time; the other is four VCOs through two VCAs, modulated by two different master sine waves, with the EML internal spring reverbs and reverb from the MIDIVERB II."