The Finish Line

video upload by davidryle

"Having a little fun with the Q960 sequencers and the Moog Matriarch.

The Q960 pair are set up for index sequencing on the bass line. This is a fun way to mangle the bass line but keep it steady in time with the drum pattern. The gate duty was handed to the Dotcom Q172 quantizer for only sending gates when there is a change of pitch voltage. This helped to avoid the typical pulse rhythm.

The bass voice is a pair of Synthetic Sound Labs TZ-VC Oscillators in FM coupling. There is a third VCO from SSL for a sine wave sub-oscillator. These are mixed through the Corsynth C114 transistor drive mixer to the Oakley Voltage Controlled State Variable Filter in low pass mode. The signal is split and sent through the Modcan 73B stereo echo delay and also a dry signal is driven by a second Corsynth T-Mixer for added saturation.

The drum sounds are from the Delptronics LDB-2E and the TipTop SD808 snare. There is a Mutable Instruments Grids and the Moon Modular 563 trigger sequencer coupled to trigger the modules. The snare is sent through the MakeNoise Echophon delay and produces the raspy pulse voice heard throughout.

A hollow wood/metal block percussive sound is generated by a pair of Dotcom Q106's, a Mega Ohm Audio CdS LPG and an SSL Digital Delay. This is triggered by the STG Trigger Mini Store and reset by the Moon 554 Octal Clock Divider.

The IN-YER-FACE lead line is the Moog Matriarch through a T.C.Electronics D-Two delay unit.

Clock source was from Cubase through the STG Time Divider.

A pair of Dotcom Q962 Sequential Switches were used to route the various step gates from the lower Q960 Sequencer to the upper Q960. Routing and pitch values were pre-determined after hours of rehearsal to set up a particular scale or mode that determined what I should play on the Matriarch.

It should be noted that certain happenstance values of the sequence pattern produced passing tones that lead to the typical blues scale in C. I just had to go with it."