Thursday, October 13, 2016
MakeNoise Mysteron - Retrometabolism
Published on Oct 13, 2016 Richard Devine
"This patch was inspired from the Industrial Guitar Tones patch from the Mysteron Manual via (Walker Farrell (@VortexRanger). Instead of using a DPO in tune to a fth, or octave + above Mysteron I used a intelljiel quantizer, shifting through a 5 note scale, which was running into the Pitch1 input. The output was then put into a Synthesis Technology E580 resampling mini-delay, setting the offset time very low, while setting the feedback almost at 90%. Mix was set at 50%, while the offset CV control was being controlled by channel 1 output on the Modcan Quad LFO, which was being clocked by the SSF Ultra Random. The output from here was sent to the MakeNoise Erbverb reverb, that was being controlled by the seed out on the Animatter BrainSeed module, which was clocked from a SSF UltraRandom and using the A, A/B and B S&H outputs going into the "type", !!, "generation"and "depth" inputs. 4 note low bassline using one MakeNoise STO sequenced from one Brains and Pressure Points, running and /8 clocked speed from the A-160 Clock/Trigger Divider. Purple noise output creating the micro hi-hats triggered swing triplets via the 4ms QCD, and slow white noise rises from the SSF white noise output, controlled by a Dixie "triangle" wave output running and synced at a slow rate. Noise output then running into the Mungo d0 adding little glitches to the signal. The kick drum is the Tiptop 808 BD, set with a very short decay time, sequenced from channel 1 on the TriggerMan. Rich 4 part harmony chords recorded from a Roland Jupiter-6, and then played from the Qu-Bit Nebulae module triggered in time by a divided 32 from the doepfer A-160 to reset loop playback with the entire sequence. Reverb throws from multiplied output from Mysteron into the intelljiel HexVCA, channel 6 being opened by channel 4 random S&H output from the Modcan Quad LFO. Scattered single notes via the Mutable Instruments Braids triggered by the intelljiel "uscale", 16 note lowpass gate openings via the Optomix.
makenoisemusic.com/mysteron.html"
ElectroFunk Sequential Circuits Prophet 5 Synthesizer Tribute
Published on Oct 13, 2016 Superfunk Synths
"ElectroFunk Sequential Circuits Prophet 5 Tribute
All parts played on a Prophet 5 rev 3.3"
Update:
Vermona TwinCussion quick Oscillators test
Published on Oct 13, 2016 Ziad Sarrouh
"Quick test showcasing the Vermona TwinCussion Oscillators."
New Model MOOG MODEL 15 MODULAR SYNTHESIZER SN 032/150
Note: Auction links are affiliate links for which the site may be compensated.
via this auction
"This is a MOOG MODEL 15 MODULAR SYNTHESIZER. Serial #32 out of 150, in like new condition, & perfect working order. Sounds are fantastic ! I'll miss this one but I'm spending more time on horns these days. There is a replica Moog vintage sticker on the side which I can peel off if desired, tolex is perfect.
There is also a replica vintage Moog hang tag, hanging on to the handle with string. Included are the modular synthesizer, cover, three Moog S-Trigger cables, eight new Hosa 3ft. 1/4" colored cables, one 3' & one 1' Synthesizers.com 1/4" cables, one 4' 1/4" to male S-Trigger, & the AC power cable. The original box is included."
Thought the tag was a nice touch.
via this auction
"This is a MOOG MODEL 15 MODULAR SYNTHESIZER. Serial #32 out of 150, in like new condition, & perfect working order. Sounds are fantastic ! I'll miss this one but I'm spending more time on horns these days. There is a replica Moog vintage sticker on the side which I can peel off if desired, tolex is perfect.
There is also a replica vintage Moog hang tag, hanging on to the handle with string. Included are the modular synthesizer, cover, three Moog S-Trigger cables, eight new Hosa 3ft. 1/4" colored cables, one 3' & one 1' Synthesizers.com 1/4" cables, one 4' 1/4" to male S-Trigger, & the AC power cable. The original box is included."
Thought the tag was a nice touch.
Moog MiniMoog Voyager Aluminum Edition 2015
Note: Auction links are affiliate links for which the site may be compensated.
via this auction
"Minimoog V Aluminum #97/100. Only 50 of the 100 made were made available in the United States so this is a very rare and collectible Synth. I paid $3500 new for this baby and have had it for about a year. Its resided in my smoke free studio and stayed under its lovely velvet lined cover when not in use. Its like new with no scuffs or marks or anything. I have all the original packing form the factory (pictured) and it'll be shipped in its original box. I am even throwing in the LED light and cover which are operate accessories worth over $100..."
via this auction
"Minimoog V Aluminum #97/100. Only 50 of the 100 made were made available in the United States so this is a very rare and collectible Synth. I paid $3500 new for this baby and have had it for about a year. Its resided in my smoke free studio and stayed under its lovely velvet lined cover when not in use. Its like new with no scuffs or marks or anything. I have all the original packing form the factory (pictured) and it'll be shipped in its original box. I am even throwing in the LED light and cover which are operate accessories worth over $100..."
Roland Jupiter 8 Synthesizer With Midi Fully Serviced SN 131061
Note: Auction links are affiliate links for which the site may be compensated.
via this auction
"Below is the work that was carried out on the unit from the work order July 2016
'Located and replaced failed Roland BA6632 VCA on lower module controller board. This was killing the VCF LFO on lower voices. Cleaned up gain selector switch. Replaced failed CA3046 transistor array which killed voice 4 VCO 2. Cleaned bad key contacts. Cleaned bad sliders. Replaced perished rubber buffers on the pitch bender. Calibrated bender and mod controls. Repaired dry solder joint on volume board that was silencing the upper output. Cleaned up all of the intermittent switches and controls'"
via this auction
"Below is the work that was carried out on the unit from the work order July 2016
'Located and replaced failed Roland BA6632 VCA on lower module controller board. This was killing the VCF LFO on lower voices. Cleaned up gain selector switch. Replaced failed CA3046 transistor array which killed voice 4 VCO 2. Cleaned bad key contacts. Cleaned bad sliders. Replaced perished rubber buffers on the pitch bender. Calibrated bender and mod controls. Repaired dry solder joint on volume board that was silencing the upper output. Cleaned up all of the intermittent switches and controls'"
Roland Juno 106s
Note: Auction links are affiliate links for which the site may be compensated.
via this auction
"This unit has recently been serviced extensively by vintage synth expert Steve Jones which included servicing all 6 voice chips which included running them in for 12 continuos hours in a heat controlled environment to ensure they wont fail. New speakers have been installed and the unit itself has been tested and checked meticulously.
The 106s is identical to the 106 only that it has speakers for home use. If you plug a lead into the output jack it will bypass the onboard speakers for studio or stage use.
This unit has been tagged as it was used on stage by an artist who recently performed using it with the Sydney Symphony Orchestra"
via this auction
"This unit has recently been serviced extensively by vintage synth expert Steve Jones which included servicing all 6 voice chips which included running them in for 12 continuos hours in a heat controlled environment to ensure they wont fail. New speakers have been installed and the unit itself has been tested and checked meticulously.
The 106s is identical to the 106 only that it has speakers for home use. If you plug a lead into the output jack it will bypass the onboard speakers for studio or stage use.
This unit has been tagged as it was used on stage by an artist who recently performed using it with the Sydney Symphony Orchestra"
Roland System-100 Model 101 Monophonic Synthesizer
Note: Auction links are affiliate links for which the site may be compensated.
via this auction
"CV/GATE MOD installed on buyer's request
CV signal level shift mod...
Old roland monosynths (like this 101 and SH-5) have F = 1[V] CV protocol while most of analog synths have C = 1[V], it means when you feed CV signal to other standard analog synth and play C key, the standard synth will sound F.
To adjust this mismatch we can install CV level shift circuit in CV OUT section.
GATE signal level shift mod...
Old roland monosynths (like this 101 and SH-5) require more than 10[V] GATE signalto start and contol EG (envelope generator) while most of modern analogue synths needs about 5[V], it means modern CV/GATE keyboards that feed 5[V] GATE signal won't start 101 EG.
To adjust this mismatch we can install GATE level shift circuit in GATE IN section."
via this auction
"CV/GATE MOD installed on buyer's request
CV signal level shift mod...
Old roland monosynths (like this 101 and SH-5) have F = 1[V] CV protocol while most of analog synths have C = 1[V], it means when you feed CV signal to other standard analog synth and play C key, the standard synth will sound F.
To adjust this mismatch we can install CV level shift circuit in CV OUT section.
GATE signal level shift mod...
Old roland monosynths (like this 101 and SH-5) require more than 10[V] GATE signalto start and contol EG (envelope generator) while most of modern analogue synths needs about 5[V], it means modern CV/GATE keyboards that feed 5[V] GATE signal won't start 101 EG.
To adjust this mismatch we can install GATE level shift circuit in GATE IN section."
Oberheim OB-XA Analog Synthesizer with Encore MIDI
Note: Auction links are affiliate links for which the site may be compensated.
via this auction
"Vintage Oberheim OB-Xa programmable polyphonic analog synthesizer in excellent condition with Encore MIDI and Memory expansion. This synth has been fully serviced, calibrated, tuned, and has also had new key bushings installed. Works, looks, and sounds amazing. Shipping anywhere within the USA will be $225.00. The price includes full insurance and custom packaging so that the synthesizer arrives safely to you.Please contact me if you are located outside of the USA and would like a shipping quote. Local pickup is welcomed and much preferred. I have lots of other vintage and newer musical gear for sale. Please check my other listings."
via this auction

Sequential Circuits Prophet 10 With Midi
Note: Auction links are affiliate links for which the site may be compensated.
via this auction
Looks like SN 0138
"Sequential Circuits Prophet 10 With Midi
Keyboard was repaired now in working order
However some keyboard contacts and one pot will need re cleaning plus the tape drive works sometimes.
Due to it's been sitting since it's repair about
two years ago I do have the work order to prove
The cost to get it up and running was over $800"
via this auction
Looks like SN 0138
"Sequential Circuits Prophet 10 With Midi
Keyboard was repaired now in working order
However some keyboard contacts and one pot will need re cleaning plus the tape drive works sometimes.
Due to it's been sitting since it's repair about
two years ago I do have the work order to prove
The cost to get it up and running was over $800"
PREVIOUS PAGE
NEXT PAGE
HOME
© Matrixsynth - All posts are presented here for informative, historical and educative purposes as applicable within fair use.
MATRIXSYNTH is supported by affiliate links that use cookies to track clickthroughs and sales. See the privacy policy for details.
MATRIXSYNTH - EVERYTHING SYNTH













© Matrixsynth - All posts are presented here for informative, historical and educative purposes as applicable within fair use.
MATRIXSYNTH is supported by affiliate links that use cookies to track clickthroughs and sales. See the privacy policy for details.
MATRIXSYNTH - EVERYTHING SYNTH