MATRIXSYNTH: New North Coast Synthesis MSK 007 Leapfrog VCF

Thursday, November 09, 2017

New North Coast Synthesis MSK 007 Leapfrog VCF


And we have a new maker featured on the site.

via North Coast Synthesis Ltd.

"Not Your Grandmother's Synth Filter (Yet)

There are hundreds of analog synthesizer VCFs, but only a few core designs. You've got your Moog transistor ladder and imitators that use diodes or other substitutes; you've got your two-pole state variable filter, maybe cascaded to get additional poles; and that's about it. Your grandmother was making electronic music with these designs in the 1960s, and not much has happened since. There are a few more options available in digital and semi-digital (such as switched-capacitor) architectures, but most analog designers have given up trying to create really new filters. Instead, they compete on how well they can imitate or clone specific "vintage" filters.

The North Coast Synthesis MSK 007 Leapfrog is new and different, with a sound all its own. The fifth-order "leapfrog" core topology, with five integrators and multiple feedback loops, originates in scientific work more recent than the 1960s and as far as we know never before available in a modular synth VCF. The near-elliptic response curve has an extremely sharp cutoff, with ripple in the passband and nulls in the stopband at frequencies chosen to be musically relevant.

Sweep the cutoff and hear each harmonic pop into existence and wobble around before the next one arrives. Choose a timbre, and the temperature compensated volt per octave tracking will keep it consistent across the frequency range. Change it up with exponential and linear frequency modulation. There's even a built-in VCA, because you can never have too many VCAs.

The MSK 007 is available as a pre-built 16HP Eurorack module, a DIY kit, or as bare boards. It's the perfect gift for Grandma or any other electronic musician in your life.

All-new design, not a clone or imitation of anything else
Ultra-sharp five-pole near-elliptic low-pass response, 61dB/octave at the least steep part of the main cutoff slope, with peaks and nulls at musically relevant frequencies
Built-in VCA switchable to feedback or output modes from the front panel - no jumpers
Temperature compensated V/octave tracking
Through-hole for easy hand construction and maintenance
Connectors between boards, and panel controls mounted on a board - no flying wires
No compromises on component quality: real aluminum panel, not PCB material, with colour printing; nickel and gold plating on the circuit boards; smooth-touch conductive plastic panel potentiometers rated for one million operations; polystyrene integrator capacitors; close-tolerance metal film fixed resistors; multiturn trimmers.
Fully open design - no lock-in
Specifications

16HP Eurorack synthesizer module, 58mm deep including mated power cable.
Maximum current requirements in normal use: 70mA +12V, 65mA -12V. Reverse-connection protected.
Build difficulty: intermediate to advanced, because of the number of parts and adjustment steps. All through-hole. Multimeter and dual-trace digital oscilloscope are recommended for adjustment, with other options possible."

No comments:

Post a Comment

PREVIOUS PAGE NEXT PAGE Home




©2017 Matrixsynth - All posts are presented here for informative, historical and educative purposes as applicable within fair use.
MATRIXSYNTH - EVERYTHING SYNTH
privacy policy