Noise Reap Eurorack Votlage Sequencer Module

Note: Auction links are affiliate links for which the site may be compensated.

via this auction

Note this appears to be the first Noise Reap post on the site.

Details:

"9 step voltage sequencer with hold and reset functions. Patch-able gate outputs. Loops at 9 steps if no information is given to the RST or HLD inputs.

specifications:

eurorack 22hp
skiff friendly
reverse voltage protected
In/Outs:

CLK - clock input (for square wave LFO, dedicated clock module, etc)
HLD - a positive voltage here will cause the clock input to be ignored, therefore holding on the current step
RST - a positive voltage here will return the sequencer to step one ( clock will not start counting again until RST voltage is low again)
CV out - voltage output corresponding to knob position (+/- 2 volts, noon is 0 volts)
HLD@ - same as HLD (note: if a cable is patched form 5 to HLD@, the sequence will be 5 steps long and stop at step 5)
RST@ - same as RST (note: if a cable is patched from 5 to RST@, the sequence will be 4 steps long and loop)
outputs 2-9 - any given ouput will be high (+5 volts) for as long as the corresponding step is active."