MATRIXSYNTH: Saturday, July 6, 2019

Saturday, July 06, 2019

L.O.R.D. : Digitone || ClusterFlux || Analog Heat || Dark World


Published on Jul 6, 2019 Wingo Shackleford

"Afternoon ambient jam with Elektron Digitone and Analog Heat. Special appearance from the Moog ClusterFlux. Reverb is Chase Bliss Audio's Dark World, and mixer is a Soundcraft MTK recording into Ableton."

The Quickening- An Ode to Art Bell featuring the Kurzweil K2500XS written in 1996


Published on Jul 6, 2019 Sean Christopher Evoking Emotion with Synthesizers

"I've been too busy on other project unfortunately to get a new track up in the past several weeks, so I thought that I would share with you a track I wrote back in 1996 on the Kurzweil K2500XS, a mid-90's digital synth/sampler extraordinaire. I loved my Kurzweil's back in the 90's having owned a K2000, a K2500XS, and later 2 K2600XS's.

The Quickening- An Ode To Art Bell is a piece I wrote that features samples from the old Coast To Coast AM Radio Art Bell show from the "Kingdom of Nye". Back in those days I worked a "real" job at the US Postal Service on the graveyard shift. The Art Bell show kept me entertained for 3 or 4 hours every night with talk on just about every paranormal subject out there. I wrote and composed the music and the lyrics. The singer for a band i was in at the time provided the vocals. Her name is Amy....sorry, I cannot recall her last name right now."

Sequential Circuits Prophet VS SN 0391 Serviced with Upgrades


via this auction

Pics of the inside below.

"Important upgrades are as follows.

The display was upgraded to OLED.

All push buttons were replaced within the past year.

The original aftertouch system was upgraded to utilize the common Fatar pressure sensor installed underneath the actual keys in place of the felt so when you depress the key it engages the aftertouch very easily. The entire keybed was disassembled and cleaned during the process.

The failure prone CEM 5530 chips have been replaced with very reliable clones from Straylight engineering."

Vintage Oberheim MS-1 Mini-Sequencer SN 0005


via this auction

"Low serial Oberheim MS-1 Mini-Sequencer, made in January 1976. The sequencer is just been serviced and ready for the future. Cosmetically it's in used condition with signs of use on the front panel and case, a few scratches and wear and tear (see photos). The unit is working on 105-125v and has a Japanese plug on the lead. The serial number is: 0005"

op-z jam (Optigan & Massive samples)


Published on Jul 6, 2019 thebrackett

"Here's another jam using some Optigan and N.I. Massive Samples for lead and bass, and some rhythm stuff using a chopped up version of the default speech synthesis track that loads when you initialize a rhythm sampling track.

Also, pardon the wobbly table, I'll cram a matchbook under it next time so it don't shake so much.

Thanks for watching!"

OP-Zs on eBay | OP-Zs on Reverb | OP-Zs on Amazon

Synth Rorschach #66: PPGs Ready to be Connected at Apollo Mission Control


via bÖsch


"Loads of PPGs ready to be connected"


You might recognize this from: Synth Rorschach #64: Apollo Mission Control. Nice contrast in this shot compared to the color and perceived hustle and bustle in the previous post.

Moog Voyager XL Keyboard Synthesizer


via this auction

"Moog Voyager XL Keyboard Synthesizer. Condition is Preowned but very lightly used. Some VERY minor cosmetic flaws to the wood frame around the corners but other than that in PERFECT condition. Comes with power cable, patch cables, and pedal."

Korg Wavestation SR 90’s Vintage Rackmount Digital Wavetable Synthesizer


via this auction

Synton VCF 3017 Synthesizer Filter Module


via this auction

"Up for sale is a very rare Synton Voltage Controlled Filter (VCF) module, model 3017, made in Holland. This was intended to fit into their large modular synthesizer systems from that era.

I purchased this synthesizer filter module in the mid 1980s from an authorized Synton dealer, and never got around to using it. It's UNTESTED but it's as new as when I bought it. It's in excellent condition although there is one very small paint imperfection from the factory on the front panel, between the input jack and the band pass output jack. It requires a +/- 15 volt DC power supply (which I've never had access to, and that's why I never powered it up).

It has one audio input, a voltage control input, a Band Pass output (BP), and an output for Low Pass / N / High Pass. The controls are one knob for Input Attenuation, one for Frequency, one for Resonance, and a knob to change between Low Pass, Notch, and High Pass filtering. And there's a red LED to indicate Overload.

This synth module uses standard banana jacks, so it can connect to other devices using the same type of jack, or can be used with third-party adapter cables or modules (verify with your technician).

Dimensions (approx):

128 mm tall (5 1/6th inches)
80 mm wide (3 3/16th inches)
50 mm deep (2 1/8th inches) (total including knobs)
34 mm deep (1 3/8th inches) (from panel to farthest PCB component)

The power wires extend approximately 18" from the printed circuit board. See photos to view power connector.

Could this be the retro module you're looking for to fit into your system? Maybe so!

It requires +/- 15 volts DC, so please verify that this will work with your system before bidding. (Euro-rack systems run on +/- 12 volts DC, so if you want to use this with a Euro-rack system, you'll need a separate power supply.)"

Korg VC10 Vintage Analog Vocoder


via this auction

"Korg VC-10 analog vocoder. It works perfectly and sounds amazing. Cosmetically there's some pitting and oxidization on the face, remnants of a sticker on the back, and general bumps and scrapes typical of an old synth. The gooseneck mic is the same make and model as the original, but is newer."

Access Matrix Programmer SN A19600544


via this auction

Programmer for the Oberheim Matrix-6, Matrix-6R, and Matrix-1000. Note this requires at least OS 2.13 on your Matrix-6 and 6R. Before making synths Access made programmers. Specifically the Matrix and Waldorf Microwave programmers.

ROLAND Tr909 DrumMachine Techno Clap in Eventide H910 Harmonizer


Published on Jul 6, 2019 Sound Provider

"For this quick exemple I did a quick Techno loops and put a clap from a Roland Tr-909 Drum machine through an Eurorack Tiptop Audio z-dsp with halls of Valhalla reverb card them I put it through my Wonderful Eventide H910 Harmonizer.
The Eventide H910 Harmonizer was developed by Eventide in 1974. The H910 was the world’s first commercially available digital audio effects device. It combined ‘de-glitched’ pitch change with delay and feedback.
I record everything with Roland Go:mixer pro and the lever was little too hot, so sorry for the little distortion."

SONICWARE ELZ_1 - Jam with Elektron Octatrack


Published on Jul 6, 2019 Masaki Takada

"Octatrackからプログラムチェンジを送信して、ELZ_1のプリセットを次々と切り替えながら遊んでみました。

I sent program change from Octatrack and played while switching presets of ELZ_1 one after another."

DreadBox Hypnosis - Space Rain


Published on Jul 6, 2019 Dawless Jammin'

Patch of the week 14: Twin Peaks style E-piano on minilogue xd


Published on Jul 6, 2019 Korg

"Creating a vintage synth-piano sound for spooky Twin Peaks vibes on Korg minilogue xd!"

Korg Patch of the week videos.

Lyra-8 No Talk Drone Noise Demo Part 6 // Lyra-8 Organismic Drone Synth Demo


Published on Jul 6, 2019 Ron Cavagnaro

"Please make sure to keep your volume at a moderate level. Due to the experimental quality of this synth some parts may become noisy to some, and extremely irritable to others."
PREVIOUS PAGE NEXT PAGE HOME




© Matrixsynth - All posts are presented here for informative, historical and educative purposes as applicable within fair use.
MATRIXSYNTH is supported by affiliate links that use cookies to track clickthroughs and sales. See the privacy policy for details.
MATRIXSYNTH - EVERYTHING SYNTH